If you need further assistance please contact the Patterson Technology Center for further troubleshooting.For Hardware Type, in the drop down box, please make sure that you have the "CDR HS Remote" listed. Click on the "Schick Sensor" button under Device Properties.If you are able to get your remote and sensor information to show, please continue to step 4.In here you should see the remote firmware listed, along with the serial number and firmware for your sensor. If you do not, make sure that Eaglesoft/Patterson Imaging is closed and try the utility again. Go to the Start Menu on your computer, look for "CDRDicom For Windows" and then "CDR USB Remote HS Utility".If you need further assistance, please contact the Patterson Technology Center for further troubleshooting. CDR Phoenix + HS Remote Check to make sure that your cables are connected properly.Test the sensor, make sure that you are choosing an exam that was created for the sensors.For Hardware Type, in the drop-down box, please make sure that you have the "Elite Remote" listed. Schick USB Module and Sensors User Guide. Get unprecedented image quality and control from Schick 33, the next generation in intraoral digital radiography. Here you should have "Sensor" set as your default device and "Schick Sensor" set as your default sensor. Check preferences in Eaglesoft/Patterson Imaging under File | Preferences/General Preferences | XRay Tab.If you can get your remote and sensor information to show, please continue to step 4.If you are unable to get your equipment to recognize in the utility, your issue is most likely hardware related and you need to contact the Patterson Technology Center for assistance.If you still do not see your remote and sensor information, try swapping equipment with another room or change the USB cable.Please see FAQ 20595 - Schick Sensor Installation If you do not have the option for CDRDicom For Windows or the Utility, you are missing the remote's driver.In here you should see the remote firmware listed, along with the serial number and firmware for your sensor? If you do not, make sure that Eaglesoft/Patterson Imaging is closed and try the utility again. Go to the Start Menu on your computer, look for "CDRDicom For Windows" and then "Upgrade Utility".Make sure you are not using any USB extenders or powered USB hubs.Make sure that the sensor is connected to the remote and the remote is connected to the USB cable. Please disconnect/reconnect these cables as a troubleshooting step. Check to make sure that your cables are connected properly.Make sure that the sensor is connected to the remote and the remote is connected to the USB cable that runs directly into the computer's USB port. Check to make sure that your cables are connected properly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |